I 9000 repair boot+flash ok by octoplus

Page size : 4096 bytes Block size : 64 pages (256 Kb) Block count: 2048 Flash size : 512 Mb Write protection disabled. Opening "C:\Users\Renall\Downloads\SAMSUNG_GTI9000_Repair. mf" file... Repair restarted at last fail position. Writting BOOT section. Please wait... Done Writting UPCH section. Please wait... ERROR[018]: Logical block operation failed at 524032 Kb (Hex address 0x1FFC0000). Reason: Connection lost. VREF = 0.0V is less than required level. Please check target device power supply. Medusa JTAG Firmware version 1.1.0. Medusa JTAG Hardware S256 revision C. ERROR[030]: TDO is constant high. Please check target device connection. MI: Medusa JTAG init failed. Please connect the target device and power it on... Medusa JTAG Firmware version 1.1.0. Medusa JTAG Hardware S256 revision C. Detected TAP ID: 1BA00477, IR Length = 4. JTAG speed : 12000 KHz. VREF level : 2.86 V CPU : Samsung S5PC110 Core ID : 1BA00477 Flash device: Samsung OneNAND KFG4GH6Q4M Flash ID : 00EC0050 Page size : 4096 bytes Block size : 64 pages (256 Kb) Block count: 2048 Flash size : 512 Mb Write protection disabled. Opening "C:\Users\Renall\Downloads\SAMSUNG_GTI9000_Repair. mf" file... Repair restarted at last fail position. Skipping BOOT section. Writting UPCH section. Please wait... Done Disconnected Repair done.Welcome to Octoplus/Octopus Box Samsung software version 1.2.6
-----------------------------------------------------------------------------------
To connect GT-I9000 phone you have to perform the following steps:
1. Disconnect USB cable from phone.
2. Go to Menu->Settings->Applications->Development.
3. Turn on "USB Debugging" option.
4. When message is appear press "Yes".
5. Go to dial window.
6. Enter "*#7284#" number.
7. Set "USB" radio button to "PDA" value.
8. Close window.
9. Go to dial window.
10. Enter "*#9090#" number.
11. Set "Diag config" to "USB" value.
12. Restart phone.
13. Press "Read Info" in software.
Selected firmware file: I9000DXJV9_OLBJV9_DXJV9.oct
Please switch your phone to the download mode and connect it to a
PC.
To put GT-I9000 phone into download mode you have to perform the
following steps:
1. Reconnect phone battery.
2. Press and hold "Volume-" +"Power"+''Home" buttons.
Writing firmware Canceled
Please switch your phone to the download mode and connect it to a
PC.
To put GT-I9000 phone into download mode you have to perform the
following steps:
1. Reconnect phone battery.
2. Press and hold "Volume-" +"Power"+''Home" buttons.
Found phone on
Firmware write started.
Writing MODEM section...
MODEM section has been written successfully.
Writing CACHE section...
CACHE section has been written successfully.
Boot section skipped
Writing FACTORYFS section...
FACTORYFS section has been written successfully.
Writing PARAM section...
PARAM section has been written successfully.
Boot section skipped
Writing KERNEL section...
KERNEL section has been written successfully.
Firmware writing successfully completed.