1100 thay flash???????

1100 mất nguồn,đưa vào JAF không nhận cáp mình thay Flash đã nhận cáp thì báo như vậy nè:
Getting MCU ID
Phone didn't answer with TX line low after UEM reset!
Causes:
1. put a 27-33 pico capacitor in connector b/w mbus-gnd.
2. UEM damaged -> replace uem.

MCU ID: 0xDDDD
Failed! Aborting!
Done!
Phone Restarted...
FILES SET FOR FLASHING:
MCU Flash file: NONE
PPM Flash file: NONE
CNT Flash file: NONE
ADSP Flash file: NONE
APE Variant file: NONE
APE User Flash file: NONE
Switching to serial...
Powering the phone...
Failed! Aborting!
Phone Type:
FILES SET FOR FLASHING:
MCU Flash file: H:\FLASH FILE DCT4\1100 rh-38\rh38_08.110
PPM Flash file: NONE
CNT Flash file: NONE
ADSP Flash file: NONE
APE Variant file: NONE
APE User Flash file: NONE
Phone Type:
FILES SET FOR FLASHING:
MCU Flash file: H:\FLASH FILE DCT4\1100 rh-38\rh38_08.110
PPM Flash file: H:\FLASH FILE DCT4\1100 rh-38\rh38_08.11qc
CNT Flash file: NONE
ADSP Flash file: NONE
APE Variant file: NONE
APE User Flash file: NONE
Backing up PM Field 208 as RPL...
Setting local mode...
Failed! Aborting!
Failed to backup imei...
MCU: H:\FLASH FILE DCT4\1100 rh-38\rh38_08.110
Booting phone...
Phone didn't answer with TX line low after UEM reset!
Causes:
1. put a 27-33 pico capacitor in connector b/w mbus-gnd.
2. UEM damaged -> replace uem.
MCU ID: 0xDDDD
This MCU ID is not supported in chosen flash file...
Error booting phone...
anh nào biết chỉ cho cách làm với nhé.

bạn thay luôn con uem xang nữa đi

ban doi sang hop hwk hoac mt bõ chay xem sau ban .tu tu ha thay u

Booting phone...
Phone didn't answer with TX line low after UEM reset!
Causes:
1. put a 27-33 pico capacitor in connector b/w mbus-gnd.
2. UEM damaged -> replace uem.
MCU ID: 0xDDDD
This MCU ID is not supported in chosen flash file...
Error booting phone...

Cái này thì thay UMEM nữa mới ok