1100 mất nguồn,đưa vào JAF không nhận cáp mình thay Flash đã nhận cáp thì báo như vậy nè:
Getting MCU ID
Phone didn't answer with TX line low after UEM reset!
Causes:
1. put a 27-33 pico capacitor in connector b/w mbus-gnd.
2. UEM damaged -> replace uem.

MCU ID: 0xDDDD
Failed! Aborting!
Done!
Phone Restarted...
FILES SET FOR FLASHING:
MCU Flash file: NONE
PPM Flash file: NONE
CNT Flash file: NONE
ADSP Flash file: NONE
APE Variant file: NONE
APE User Flash file: NONE
Switching to serial...
Powering the phone...
Failed! Aborting!
Phone Type:
FILES SET FOR FLASHING:
MCU Flash file: H:\FLASH FILE DCT4\1100 rh-38\rh38_08.110
PPM Flash file: NONE
CNT Flash file: NONE
ADSP Flash file: NONE
APE Variant file: NONE
APE User Flash file: NONE
Phone Type:
FILES SET FOR FLASHING:
MCU Flash file: H:\FLASH FILE DCT4\1100 rh-38\rh38_08.110
PPM Flash file: H:\FLASH FILE DCT4\1100 rh-38\rh38_08.11qc
CNT Flash file: NONE
ADSP Flash file: NONE
APE Variant file: NONE
APE User Flash file: NONE
Backing up PM Field 208 as RPL...
Setting local mode...
Failed! Aborting!
Failed to backup imei...
MCU: H:\FLASH FILE DCT4\1100 rh-38\rh38_08.110
Booting phone...
Phone didn't answer with TX line low after UEM reset!
Causes:
1. put a 27-33 pico capacitor in connector b/w mbus-gnd.
2. UEM damaged -> replace uem.
MCU ID: 0xDDDD
This MCU ID is not supported in chosen flash file...
Error booting phone...
anh nào biết chỉ cho cách làm với nhé.