Call barrier Possible only if bypass of the service code is switched off.
Check code (S):
S=33 all outgoing transmissions
S=331 outgoing abroad
S=332 outgoing abroad except home
S=35 all arriving transmissions
S=351 all arriving abroad

Special check codes (s) delete:
Switch off only in connection with the procedure
S=330 check code status outgoing & arriving transmissions switch off
S=333 check code status outgoing transmissions switch off
S=353 check code status arriving transmissions switch off
Service code (D):
Not all nets support all services
D=10 language and fax (all calls)
D=11 only language
D=12 all data (speed/minutes)
D=13 only fax
D=14 DATEX j (active?)
D=15 teletex (active?)
D=16 only SMS
D=18 all data except SMS
D=19 all services except SMS
D=20 all services
D=21 all asynchronous services
D=22 all synchronous services
D=23 3.1 kHz GSM of language services
D=24 all synchronous POINT ton of POINT DATA inclusive. PADs
D=25 only data (all asynchronous POINT ton of POINT DATA inclusive. PADs)
D=26 data packet exchange links incl. PADs
D=27 services thru PADs
D=29 12 Kbps digital link


* S * [Passwort] * D # - einschalten der Anruf-Sperre
# S * [Passwort] * D # - ausschalten der Anruf-Sperre
*# S # - Status der Anruf-Sperre abfragen

Passwort für Handy Sperre ändern:
** 03 ** [altes Passwort] * [neues Passwort] * [neues Passwort wiederholen] #
** 03 * 330 *[altes Passwort] * [neues Passwort] * [neues Passwort wiederholen] #

Dies geht beim 6600 auch teilweise via Menü: Einstellungen - Anrufsperre ...
------------------------------------------------------------ ----
PIN ändern ** 04 * [alte PIN] * [neue PIN] * [neue PIN wiederholen] #
** 042 * [alte PIN 2] * [neue PIN 2] * [neue PIN 2 wiederholen] #

PIN entsperren: ** 05 * [PUK] * [neue PIN] * [neue PIN wiederholen] #
PIN 2 entsperren: ** 052 * [PUK2] * [neue PIN 2] * [neue PIN 2 wiederholen] #

Dies geht beim 6600 auch teilweise via Menü: Einstellungen - Sicherheit - Telefon und SIM
-----------------------------------------------------
Diverse Codes Die folgenden Codes klappen nur in einigen (wenigen) Netzen/Netzbetreibern ... leider z.B. nicht im Vodafone D2 Netz (in Deutschland):
*#100# - Eigene Nummer (Own Number)
*#101# - HLR Nummer
*#102# - Switch Nummer
*#103# - Zeit im Netz (Network Time)
*#104# - Anrufbeantworter Nummer (Voice mailbox number)
*#105# - Switch number
*#147# - Letzter Anrufer (Last Caller)

#646# - Minutes Used: (646 spells 'MIN')
*#1345# or *174# - Vodafone Prepaid balance

*78 - Do not disturb - nur in Nord America in GSM und CDMA Netzen möglich
*79 - Cancel (s.o.)
---------------------------------------------------
CHECK SIM-LOCK

Note - If you bought your Nokia on UK Vodafone or UK Cellnet you do not need to check this because they both transmit on GSM900, and they don't lock the phones. However if you bought your phone on UK Orange or UK One2one your phone may be blocked. The reason is that they both transmitt on GSM1800. To make a call on GSM1800 you need what is known as a "Dual band" phone. A dual band phone is able to transmit on both GSM900 and GSM1800, so they lock the phones so you can't use it with any other network simcard. If you find that your phone is locked you can try different software to unlock it. (we havn't found one that works yet), or you can ask your service provider who will gladly exchange the 10 digit code for about £35.

This is how to check the status of the 4 different locks. Aslo don't try entering the wrong number, because after 3 times it will block the phone for good.



There are 4 different locks on your Nokia phone.

COUNTRY-LOCK

NETWORK-LOCK

PROVIDER-LOCK

SIMCARD-LOCK

The code to read out the sim-lock status of your phone is



#PW+(MASTERCODE)+(Y)#

# = DOUBLE-CROSS

W = PRESS "*" THREE TIMES

P = PRESS "*" FOUR TIMES

+ = PRESS "*" TWO TIMES

MASTERCODE = 1234567890

Y = NUMBER 1 TO
-------------------------------------
THE JAMES BOND TRICK

If you short-circuit theleft middle and right pins on the bottom of the phone with all connections touching each other, the Nokia software hangs! The profile "Headset" will be activated. Before you do this just activate the "Automatic Answer" in the headset profile and set the ringing volume to "Mute". Now you can use your phone for checking out what people are talking about in a room. Just place it under a table in a room and call it. The phone receives the call without ringing and you can listen to what people are saying.
-----------------------------------------------------
Clock Stopping

To check weather your SIM Card supports clock stopping type-

*#746025625# (*#SIM0CLOCK#)
---------------------------------------------
To enter the service menu type-

*#92702689# (*#WAR0ANTY#)

Serial number (IMEI)

Production date (MM/YY)

Purchase date (MM/YY) You can only enter the date once.

Date of last repair (0000=No repair)

Transfer user data to another Nokia phone via Infra-Red

NOKIA 6110/6120/6130/6150/6190


IMEI number: * # 0 6 #
Software version: * # 0 0 0 0 #
Simlock info: * # 9 2 7 0 2 6 8 9 #
Enhanced Full Rate: * 3 3 7 0 # [ # 3 3 7 0 # off]
Half Rate: * 4 7 2 0 #


NOKIA 3110


IMEI number: * # 0 6 #
Software version: * # 0 0 0 0 # or * # 9 9 9 9 # or * # 3 1 1 0 #
Simlock info: * # 9 2 7 0 2 6 8 9 #


NOKIA 3330

*#06#
This will show your warranty details *#92702689#
*3370#
Basically increases the quality of calling sound, but decreases battery length.
#3370#
Deactivates the above
*#0000#
Shows your software version
*#746025625#This shows if your phone will allow sim clock stoppage
*4370#
Half Rate Codec activation. It will automatically restart
#4370#
Half Rate Codec deactivation. It will automatically restart
Restore Factory Settings
To do this simply use this code *#7780#
Manufacturer Info
Date of Manufacturing *#3283#
*3001#12345# (TDMA phones only)
This will put your phone into programming mode, and you'll be presented with the programming menu.
2) Select "NAM1"
3) Select "PSID/RSID"
4) Select "P/RSID 1"
Note: Any of the P/RSIDs will work
5) Select "System Type" and set it to Private
6) Select "PSID/RSID" and set it to 1
7) Select "Connected System ID"
Note: Enter your System ID for Cantel, which is 16401 or 16423. If you don't know yours,
ask your local dealer for it.
8) Select "Alpha Tag"
9) Enter a new tag, then press OK
10) Select "Operator Code (SOC)" and set it to 2050
11) Select "Country Code" and set it to 302 for Canada, and 310 for the US.
12) Power down the phone and power it back on again
ISDN Code
To check the ISDN number on your Nokia use this code *#92772689#