em flah h báo thế này
MXKEY [MxKey Team HTI Flasher Interface (WinUSB) 1], SN: C0874392
Using device: HTI, FW ver: 00.24, SN: 00015515
Connection status: UHCI:HUB:USB 2.00 (Full-speed)
Driver: WinUSB, ver: 3.5.1.0
Module ver: 1.0.0.20814(05-05-2012), Library ver: 1.0.0.14060(05-05-2012)
ASIC ID: 0x2292 [UPPCosto ver: 1.3]
SecondaryBoot: u3_2nd.fia [DCT4] version: 4.76.0 revision: 0.7 size: 0x9A8
Supported Ids: 3040, 2292, 2293, 3162, 3166, 3168
FlashID0: 0089 8872 [Intel 28F320W18,32 Mbits] page size: 64 K type: NOR area: 01000000-013FFFFF
FlashID1: 0000 0001 [unused/removed]
ExtBUSC: AD7E B61A 1BBE 0BE2 7D58 6BE4 DBEE 6514
Algorithm: u3_intel.fia [DCT4 ALGORITHM] version: 4.76.0 revision: 0.7 size: 0x56A0
Supported Ids: 3040, 2292, 2293, 3162, 3166, 3168
Performing Flash Authentication ...OK
UEM ID: 00953817A3BDA66
ASIC type: 11
UEM Imei: 35310502375626
Flash Imei: 35684502754298
Invalid imei checksum !
Processing MCU file: rh99_05.710
[DCT4,DCT4 ALGORITHM] size: 2.26 MB
Supported Ids: 2292
ASIC ID: 0x2292 [UPPCosto ver: 1.3]
SecondaryBoot: u3_2nd.fia [DCT4] version: 4.76.0 revision: 0.7 size: 0x9A8
Supported Ids: 3040, 2292, 2293, 3162, 3166, 3168
FlashID0: 0089 8872 [Intel 28F320W18,32 Mbits] page size: 64 K type: NOR area: 01000000-013FFFFF
FlashID1: 0000 0001 [unused/removed]
ExtBUSC: AD7E B61A 1BBE 0BE2 7D58 6BE4 DBEE 6514
Algorithm: u3_intel.fia [DCT4 ALGORITHM] version: 4.76.0 revision: 0.7 size: 0x56A0
Supported Ids: 3040, 2292, 2293, 3162, 3166, 3168
Performing Flash Authentication ...OK
UEM ID: 00953817:2984DA60
Area [01000000-0100FFFF] erased in 0.594 s
Area [01010000-013AFFFF] erased in 32.546 s
Area [013B0000-013EFFFF] erased in 2.453 s
Area [017C0000-017EFFFF] erased in 0.016 s
Area [01FC0000-01FEFFFF] erased in 0.016 s
Flash programming ...
Programming completed in 19.781 s
File processed in 1 min 2.328 s
Processing CNT file: rh990_nai5.71mr
[DCT4,DCT4 ALGORITHM] size: 110.62 KB
Supported Ids: 2292
ASIC ID: 0x2292 [UPPCosto ver: 1.3]
SecondaryBoot: u3_2nd.fia [DCT4] version: 4.76.0 revision: 0.7 size: 0x9A8
Supported Ids: 3040, 2292, 2293, 3162, 3166, 3168
FlashID0: 0089 8872 [Intel 28F320W18,32 Mbits] page size: 64 K type: NOR area: 01000000-013FFFFF
FlashID1: 0000 0001 [unused/removed]
ExtBUSC: AD7E B61A 1BBE 0BE2 7D58 6BE4 DBEE 6514
Algorithm: u3_intel.fia [DCT4 ALGORITHM] version: 4.76.0 revision: 0.7 size: 0x56A0
Supported Ids: 3040, 2292, 2293, 3162, 3166, 3168
Performing Flash Authentication ...OK
UEM ID: 00953817:2984DA60
Area [01380000-013AFFFF] erased in 1.781 s
Flash programming ...
Programming completed in 0.984 s
Content extract fail, continue anyway ...
File processed in 50.859 s
Processing PPM file: rh99_05.71mr
[DCT4,DCT4 ALGORITHM] size: 1.13 MB
Supported Ids: 2292
Boot error: CC CC CC 00
- Repeat the procedure. Sometimes it is a matter of temporary communication problem or similar.
- Check that all used cable are solid without any visible damage and have good contact. If possible, try with other cables.
- On rare occasions phone might be damaged or dead. So, if possible, try with another phone.
flashing terminated !
Task failed at (0800002A)!!!
Last RX buffer: 02 00