đây là log check
MXKEY [MxKey Team HTI Flasher Interface (WinUSB) 1], SN: C085E726
Using device: HTI, FW ver: 00.50, SN: 000160DF
Connection status: UHCI:HUB:USB 2.00 (Full-speed)
Driver: WinUSB, ver: 3.5.1.0
Module ver: 1.0.0.19798(05-01-2012), Library ver: 1.0.0.13703(05-01-2012)
Device synchronized.
CPU: XGOLD 110
Using embedded SBL from MCU.
Sending EBL Loader ...OK
Sending EBL ...OK
Getting EBL Version ...
Boot mode: 0xCC
EBL version major/minor: 10.24
EBL version : Default_RAM_Bootloader
Set baud rate to: 921.60 Kbit/s
Flash ID: 006C 2404 [unused/removed]
chêck đén đó thì dừng
log flash
Driver: WinUSB, ver: 3.5.1.0
Module ver: 1.0.0.19798(05-01-2012), Library ver: 1.0.0.13703(05-01-2012)
Do not disconnect or abort this operation otherwise phone will be damaged.
Device synchronized.
CPU: XGOLD 110
Using embedded SBL from MCU.
Sending EBL Loader ...OK
Sending EBL ...OK
Getting EBL Version ...
Boot mode: 0xCC
EBL version major/minor: 10.24
EBL version : Default_RAM_Bootloader
Set baud rate to: 921.60 Kbit/s
Flash ID: 006C 2404 [unused/removed]
Processing file: rm713_005.440
Downloading item CODE:hw_b1_rm713_r05.440.fls, num block: 3, size: 5.58 MB
Erasing area 0x00000000-0x00005FFE ...OK
Programming completed in 0.594 s
Erasing area 0x00800000-0x00BEFFFE ...Processing file: rm713_005.44mr
Downloading item CUST:hw_b1_rm713_005.44mr.fls, num block: 1, size: 5.07 MB
flashing terminated !
tình trạng máy mất nguồn e đã đóng flash và upp rồi ,ko có đồ thay thế nên nhờ ae xem giúp còn cứu đcj ko