Video hướng dẫn chạy mcn-pro

[saigonmobile]

McnPro - Pinouts Detection Procedure - A Quick Scan Guide

----------------------
Quick scan RX ,TX
----------------------

- Txd Rxd Gnd and Api(sky cpu) Pinout Scan
- Supports MTK TI ADI INF SKY AGE OM SPD...
- Takes just a few seconds


Step by Step:

* Connect McnPro to computer and open the main software
* Connect the phone with the right cable via USB etc.
* Use our special cable to connect phone to Negative / Positive, Box can automatic identification and that already have Protection System, so don't worry about the polarity.
* Press [Scan Rx Tx]
* If you already know the based cpu in phone, just select the related one (will be fast), otherwise select "Auto" (will take a few more seconds than usuall)
* Hold power-on button of your phone and press start button on the software interface , in just a few second you will get results ,eg.
Quote:
Scanning results:
GND: 12 13 ,RXD 10, TXD 15
Quote:
Scanning results:
Spd chipset
GND: 12 13 ,RXD 10, TXD 15, Boot:6
Quote:
API Scanning results:
API Pin 4-5
* You can save the scan results , because you might need that for the flash process
* BTW, for SKY cpu it's a little be different, Api can be detected and phone can be Reset. IMEI can be change too. (plz follow the window step by step procedure, its very easy.) eg.
Quote:
Scanning results:
SKY chipset
GND: 12 13 ,RXD 10, TXD 15
Scanning API pin(Please waiting...)
>>.......
API Scanning results:
API pin 5-6
Quote:
....
Connect ok
Modify imei...
Modify successful !


----------------------
USB Scan
----------------------

- Charge / Boot pin ,USBD+/-
- Supports MTK TI ADI INF SKY AGE OM SPD...
- Will take more seconds than above step


Step by Step:

* Connect McnPro to computer and open the main software
* Connect the phone with the right cable via USB etc.
* Use our special cable to connect phone to Negative / Positive, Box can automatic identification and that already have Protection System, so don't worry about the polarity.
* Press [USB Scan]
* In select option choose the same cable which you used, Eg. Mcnpro-11
* Hold power-on of your phone and press [Read starts] button on the software interface .eg.
Quote:
...
Scanning pin-status, please waiting..
->...............................
9,10 short-pin
>>Pin-status scanning completed
* Press [Charge-pin] button Box will be start to analyzing ,then follow the window step by step to do the procedure.when computer find a new USB device which mean's all step done. eg.

Quote:
...
USB D-:8 USB D+: 7 VCC:1 GND: 6 11
...
If scan other phone ,please press [stop]