V3 sai trạng thái >> repair pds >> 1/2 chặn đường >> rút cable ....Được post bởi Dương Bửu Linh
E1 > MSS4:
1. Connect test point
2. Insert the cable. Mssv4 while display phone connected and "S Blank Neptune LTE"
3. Remove test point
4. Select "U6/L6/E1/E790" in the models list, and press "Unlock via testpoint"
WAIT and Let the software finish the job!!!!
It will:
- Backup old boot
- Erase
- Install new boot
- Finalize
Then, when the software will ask to, remove the cable from the phone and put it back, phone will be enumerated as "S blank". Press "OK".
Let the software finish the job. After that, your phone must be able to power up in both normal and flash mode!
DONT FORGET THAT YOU ONLY NEED TO GROUND THE TESTPOINT, no need to solder anything or to keep connected to the test-point. don't hold the phones in your hand during the unlocking process. Put it on the table and don't touch it.