như tiêu đề ,em mới mua volcano box chưa biết cách boot chip mstar, em đang dung tool v1.6.6 ,em đã chọn detect thành công mà vẫn không boot được ,xin mấy anh chỉ giáo Detecting D+ and D-...
Vcc: 16
Gnd: 23
Detection initiated...
D+ = 19, D- = 17
Detection D+/D- with 8,83 seconds.
Continue to detect BOOT pin...
BOOT(Pull Down) = 15 23
New USB device: (VID_EE9A&PID_F039)
Detection completed.
Setting pinouts...
Pinout setting complete.
Detection initiated...
Vcc: 16
Gnd: 23
Analyzing D+ and D-...
D+ = 19, D- = 17
Detection D+/D- with 8,97 seconds.
Continue to detect BOOT pin...
New USB device: (VID_EE9A&PID_F0B9)
Setting...
Set the Pinouts failed,please reconnect and try again!
Device not found, please re-select the port, or USB reset
If the phone ready to read and write again, please re-plug the USB or reset the pinouts.
Detection initiated...
Vcc: 16
Gnd: 23
Analyzing D+ and D-...
D+ = 19, D- = 17
Detection D+/D- with 8,81 seconds.
Continue to detect BOOT pin...
New USB device: (VID_EE9A&PID_F039)
Setting...
>>Set the Pinouts failed,please reconnect and try again!