Smart-Clip v5.00, S-Card v3.00 and SmartMoto v4.00

[HoangThong_hotrokythuat4]

Dear users,
We know that all of you have waited enough for another update, and some of you even thought we've given up…
But we are here for you and we have good news!
So, please let us introduce a new version of Smart-Clip v5.00, S-Card v3.00 and SmartMoto v4.00.

With this release we are glad to announce the following benefits.

1. Smart-Clip exclusive, unlock solution for MotoMAGX based models:
* E8
* EM30
* EM35 (beta test)
* U9
* VE66 (beta test)
* Z6w
* ZN5
* ZN5-128MB
No TestPoints or server credits required. Just a few easy steps. More details at Unlock Manual. Please pay attention to the manual, as unlock procedure of MotoMAGX models differs from usual and requires SCout multiflasher software.
2. The models W490 and W6 with boot version 0C.A1 are added to the SmartMoto list.
3. Phone model W231 is proved to be supported and added to the list.
4. Boot version 9.02 for the models V23* is supported by Prepare function.


Don’t forget to update all your products and use Smart-Clip Update Zone to update S-Card.
Make sure to update Smart-Clip BEFORE updating the S-Card.
We recommend using only the latest versions of Smart-Clip, S-Card, Smart Adaptor and SmartMoto.

If you wish to receive news on updates immediately, please subscribe to our new SMS notification system.


Smart-Clip ON!

[mt_gsmvn]

tin tức nhạy bén thiệt nà .Chúc mừng Smartclip đã tỉnh lại.

[hungphongmobile™]

Các bước unlock như sau:

E8, EM30, EM35, U9, VE66, Z6w, ZN5, ZN5-128MB
1. Connect phone to PC USB port, launch SCout multiflasher and check phone boot and fw version.
2. Log to Boot-Loader site, directory Special_MotoMAGX and from appropriate model folder download Boot_Replacer.pcf and firmware.pcf flash files.
3. Flash the phone with Boot_Replacer.pcf using SCout multiflasher.
4. Flash the phone with firmware.pcf using SCout multiflasher.
5. When flashing completes – disconnect the phone and power it ON (it must power ON to normal state).
6. Remove the battery and connect the handset to PC via Smart-Clip.
7. Launch SmartMoto.
8. In connection area select Smart-Clip USB Port (MotoMAGX)
9. Press and hold keys 4 and 6 on the phone and insert the battery. Phone starts loading and within 3-5 seconds the display should indicate the message “Motorola test mode”.
10. Release keys 4 and 6.
11. Press “Search” in SmartMoto. The phone should be detected as SCM-A11 device.
12. Log to Unlock tab and press “Unlock” button.
13. The message “Unlock – OK” informs that process completed successfully.
14. The handset restarts and can be disconnected.
Warning!
In case of performing steps 3 and 4 in wrong direction and flashing the phone with firmware.pcf file first and Boot_Replacer.pcf file after that – the phone becomes stuck in boot mode. In order to resolve it – repeat these steps in correct sequence again and continue the unlock process strictly following the manual.
Please note that unlocked phone may become locked again after flashing with full_flash. Flashing with lang_pack is safe and will not affect any functions.