Smart-Clip v5.00, S-Card v3.00 and SmartMoto v4.00

[hungphongmobile™]

Các bước unlock như sau:

E8, EM30, EM35, U9, VE66, Z6w, ZN5, ZN5-128MB
1. Connect phone to PC USB port, launch SCout multiflasher and check phone boot and fw version.
2. Log to Boot-Loader site, directory Special_MotoMAGX and from appropriate model folder download Boot_Replacer.pcf and firmware.pcf flash files.
3. Flash the phone with Boot_Replacer.pcf using SCout multiflasher.
4. Flash the phone with firmware.pcf using SCout multiflasher.
5. When flashing completes – disconnect the phone and power it ON (it must power ON to normal state).
6. Remove the battery and connect the handset to PC via Smart-Clip.
7. Launch SmartMoto.
8. In connection area select Smart-Clip USB Port (MotoMAGX)
9. Press and hold keys 4 and 6 on the phone and insert the battery. Phone starts loading and within 3-5 seconds the display should indicate the message “Motorola test mode”.
10. Release keys 4 and 6.
11. Press “Search” in SmartMoto. The phone should be detected as SCM-A11 device.
12. Log to Unlock tab and press “Unlock” button.
13. The message “Unlock – OK” informs that process completed successfully.
14. The handset restarts and can be disconnected.
Warning!
In case of performing steps 3 and 4 in wrong direction and flashing the phone with firmware.pcf file first and Boot_Replacer.pcf file after that – the phone becomes stuck in boot mode. In order to resolve it – repeat these steps in correct sequence again and continue the unlock process strictly following the manual.
Please note that unlocked phone may become locked again after flashing with full_flash. Flashing with lang_pack is safe and will not affect any functions.